VW Bus Weld-On Front Beam Adjusters | Type 2 Bus 1955–1979 | Adjustable Ride Height (16-9916-0)

VW Bus Weld-On Front Beam Adjusters — Adjustable Ride Height for Type 2 (1955–1979)

Take full control over your stance with these Weld-On Beam Adjusters. Designed specifically for the VW Type 2 Bus, these heavy-duty adjusters convert a fixed-height factory axle beam into a fully adjustable setup. Whether you want a mild drop or a more aggressive profile, they provide the mechanical versatility needed to dial in the perfect ride height.

For the "nothing to hide" fabricator, these are a staple of any beam modification project — a clean, secure way to clock your torsion leaves while keeping the suspension functional and adjustable.

Vehicle Fitment

• VW Bus (Type 2): 1955–1979

Key Features & Benefits

• Fine-Tune Your Stance: Adjust the front end to level out your Bus or clear specific wheel and tire combinations.
• Maintain Spring Tension: Rotate the center anchor point while maintaining proper tension — unlike "cutting and turning," which permanently alters spring rate.
• Future-Proof Your Build: Raise or lower the vehicle for different tire setups or storage without removing the beam again.
• Weld-On Installation: Welded to the beam tubes by a qualified fabricator; two jam nuts are included to lock in your height.

Technical Specifications

• Type: Weld-on front beam adjusters
• Included Hardware: Two jam nuts to lock ride height
• Part Number: 16-9916-0

Explore Related Categories

Browse more in Suspension VW Bus Steering.

⚠ WARNING (California Proposition 65): This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.p65warnings.ca.gov. Parts are legal for use on pre-pollution-controlled vehicles only.