King Performance Titanium Shock Spacer | Air-Cooled VW, Buggy & Off-Road | 19mm OD x 12mm ID x 35mm | Sold Individually
Couldn't load pickup availability
King Performance Titanium Shock Spacers — 19mm OD x 12mm ID x 35mm
Shock spacers are the small parts that decide whether a shock sits square in its mount or gets side-loaded until the bushing tears. King Performance makes these plain, non-threaded spacers from titanium, so they will never rust onto the shock bolt, they weigh just 26 grams each, and they finish off a mount with the same look as King's titanium bolts. Sold individually — set the quantity to the number of spacers you need (one to replace a lost spacer, or 6 to 8 to do the whole car).
Fitment
- Sized for a 12 mm shock bolt (12 mm ID) with a 19 mm OD and 35 mm length.
- Sold by King for classic air-cooled VW and off-road builds. King does not name a specific vehicle or mount location, so these suit any shock mount where a 12 mm bolt passes through a 19 mm x 35 mm spacer.
- These are a dimensional part, not a vehicle-specific kit: measure the gap in your shock mount and your bolt diameter before ordering. Send us the measurements and we will confirm they suit your mount.
Pairs well with 12 mm titanium shock hardware such as our Titanium Rear Shock Bolt & Nut Kit, 12mm x 80mm (#A16T).
Key Features
- Titanium construction: lighter than steel and completely rust-proof.
- Non-threaded sleeve: a simple spacer that locates the shock eye on the bolt.
- 26 g each (King's published weight).
- Sold individually: buy exactly as many as your mounts need.
Technical Specifications
| Brand | King Performance |
| Material | Titanium |
| Outside diameter | 19 mm |
| Inside diameter | 12 mm |
| Length | 35 mm |
| Type | Non-threaded spacer |
| Weight | 26 g per spacer |
| Sold as | Each (1 spacer) |
What's Included
One spacer per unit. No bolts, nuts or shocks are included — King's photos show parts for reference only.
Installation Notes
- Apply anti-seize to the shock bolt where it passes through the titanium spacer so it can be removed easily later.
- Check that the shock eye moves freely and is not side-loaded before final tightening.
- Torque shock bolts to the figure for your mount and re-check after the first drive.
Frequently Asked Questions
What size are the spacers?
19 mm outside diameter, 12 mm inside diameter, 35 mm long.
Are bolts included?
No, spacers only.
How many do I need?
That depends on your shock mounts. They are sold individually, so set the quantity to match — commonly 6 to 8 for a full car.
Are they threaded?
No, they are plain non-threaded sleeves.
How much do they weigh?
26 grams each.
Are they street legal?
King sells its titanium hardware for off-highway use only.
Warning
Off-highway use only.
California Proposition 65 WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Browse more King titanium in Hardware & Fasteners and Suspension.