Running dual carburetors on your air-cooled VW? The EMPI Coil Relocation Bracket moves your ignition coil off the fan shroud and mounts it directly to the engine case — clearing the way for dual-carb linkages like Weber IDF, Dellorto DRLA, or EMPI HPMX without interference.

• Relocates coil from fan shroud to engine case mounting points
• Heavy-duty zinc-plated stamped steel construction
• Fits 6V and 12V coils approximately 2 to 2.25 inches in diameter
• Dimensions: 4.5 × 1.25 × 1.25 in | Weight: 0.26 lb
• Uses existing crankcase mounting bosses — no drilling required
• Compatible with Weber IDF, Dellorto DRLA, EMPI HPMX, and similar dual-carb setups

Fits: Type 1 upright engines — VW Beetle 1950–1979, Karmann Ghia 1956–1974, Bus/Type 2 1950–1971 (upright engine), Thing 1973–1974, and dune buggies or sand rails using a Type 1 engine block.

Installation note: Verify the coil wire reaches the distributor with slack. Extend power and ignition wires if needed. Cycle throttle linkage through full travel before final tightening.