JP Group Fuel Filler Vent Hose, Filler Neck to "T", 215 mm x 15 mm | VW Beetle & Super Beetle 1968–1979 (JP-8147-0)
Couldn't load pickup availability
JP Group Fuel Filler Vent Hose, Filler Neck to "T", 215 mm — VW Beetle 1968–1979 (JP-8147-0)
Short answer: JP-8147-0 is the 215 mm fuel filler ventilation hose that runs from the fuel filler neck to the vent T-piece in the front trunk of the 1968–1979 VW Beetle. It is 15 mm inside diameter with a 2.5 mm wall (about 21 mm outside diameter). JP Group reference 8115652200. Sold each.
Part numbers: JP-8147-0 · JP Group 8115652200 · EMPI OE reference listed as "N..203631" (VW bulk hose number format) · UPC 707924524826.
Fitment
| Years | Vehicle | Notes |
|---|---|---|
| 1968–1979 | VW Beetle, incl. Convertible | Per EMPI, 215 mm length |
| 1971–1979 | VW Super Beetle | Fitment to confirm — EMPI lists "Beetle"; Super Beetle vent routing is similar but compare length with your old hose |
| 1950–1967 | VW Beetle with fuel filler under the hood | Does not fit — early cars have no external filler or vent T |
| Any | VW Bus, Karmann Ghia, Type 3 | Does not fit as listed |
Specifications
| Spec | Detail |
|---|---|
| Brand | JP Group (Denmark), distributed by EMPI |
| Part number | JP-8147-0 |
| JP Group reference | 8115652200 |
| UPC | 707924524826 |
| Position | Filler neck to vent "T" piece |
| Length | 215 mm |
| Inside diameter | 15 mm |
| Wall / outside diameter | 2.5 mm wall, about 21 mm OD |
| Weight | Approx. 0.2 lb (estimate) |
| Sold as | Each |
What's Included
- One vent hose, 215 mm.
Not Included
- Hose clamps
- Vent "T" piece and the other vent hoses
- Filler neck hose, filler neck seal and fuel cap
Why It Matters
From 1968 the Beetle got an external fuel filler on the right front fender. When you fill the tank, air in the tank has to escape through the vent system, and this hose is part of that path. If the vent hose cracks, the Beetle will smell of fuel in the front trunk and the cabin, especially after filling or on hot days, and fuel vapor can collect right in front of the driver. If the hose collapses or is kinked, the tank cannot vent, so the pump nozzle keeps clicking off and fuel can spit back out of the filler. A fresh vent hose is a simple and inexpensive cure for both problems.
Installation Notes
- Work with the tank less than half full and the battery disconnected. Open the front trunk and remove the trunk liner to reach the filler area.
- Note the routing of all vent hoses before you take anything off.
- Remove the old hose and clean the fittings. A little soapy water helps the new hose slide on; do not use oil or grease.
- Fit new clamps where the factory used them and make sure the hose does not kink or rub on the body.
- Fill the tank and check for fuel smell or wet spots at every joint.
Frequently Asked Questions
Does this fit my 1973 Beetle?
Yes. EMPI lists JP-8147-0 for the 1968–1979 Beetle with the 215 mm vent hose.
Does it fit a Super Beetle?
Probably, but EMPI lists only "Beetle". Compare length and diameter with your old hose.
Is this the filler neck hose?
No. This is the smaller vent hose. The large filler neck hose is a different part.
Can I use generic hose instead?
You can use fuel-rated hose of the same size, but this hose is cut to the factory length and is made for fuel vapor.
What size is it?
215 mm long, 15 mm inside diameter, 2.5 mm wall.
Is it new?
Yes. New, supplied by JP Group of Denmark through EMPI.
Explore Related Categories
Fuel & Intake Components VW Beetle Parts VW Super Beetle Parts
California Prop 65 Warning: This product can expose you to chemicals including lead and/or lead compounds, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, visit www.P65Warnings.ca.gov. Legal for use on pre-pollution-controlled vehicles only.
